![]() If you allow the resin to cure past the B-stage you will need to key the surface with abrasive paper before pouring the next layer.īreaking down the pours in to the 4 stages i the most important advice we can offer - it will completely seal all the faces of the wood and minimise air entrapment. Pouring on top of the layer below at it's B-stage will ensure a strong chemical bond - as though the pour was done as a single pour. Then the following pours will be made:Īfter each pour the resin must be allowed to reach the B-stage - this means that the resin has partially cured and started to become firm when touching the surface (with a gloved finger) you can make a mark but no resin sticks to your finger. For each resin stage pour out the relevant amount of pre-coloured resin and the correct amount of hardener and mix thoroughly before transferring to a second container and mixing again (this is also known as 'double-potting'). Thoroughly mix the pigment into the resin making sure you scrape the sides and bottom of the bucket.įor this project we split the resin pours into 4 stages for the different steps in the project. In the tutorial we added the neon yellow translucent tinting pigment - at a ratio of 50g of pigment per 15kg of GlassCast. This will ensure a consistent colour throughout the project. We recommend that you measure or weigh out the GlassCast® 3 resin for the entire project if you are adding a colour - like neon and pigment it all as a whole. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |